I will release this module when it is completeīasic wrote:Creating the template has been fine and pretty fun. Thanks for your time if you got this far. Lastly (for now) how do i connect one of the 'M 1' buttons to M8 itself? I know i can connect between layer 1-10 but i can't see an option to connect to one of the media panel previews? The problem i have at the moment is where do i put this variable - lpName = Akai APC20 - Akai APC20 - and what does it actually you mention setting the light colour? How do i go about that again? you started a sentence but it appears to have disappeared or was that intentional? I then viewed the code and it showed the APC20 as listed which was great. I entered this line of code in the correct place. I've been following the instructions of anomad and reading the online module manual and to be honest I've been getting a little lost this is a whole new world for me. (M 1-16 is in relation to the media panel which i want to map)Ĭreating the template has been fine and pretty fun. (Bank 1-8 is for switching between the different media banks) ![]() Ive created the layout and have named the buttons which i want to map first and after this i'll continue with the rest of the module. So ive finally started to get this module happening. so, figure out the MIDI value of the first button, then send it a val to change the led. and val is the value i want to send to the launchPad. this sends a MIDI NOTE_On to the launchpad (defined as lpName above), channel 1, NOTE_ON, note is the MIDI note for which light I want to turn on. my launchPad shows up as 'Launchpad - Launchpad', so i set a varibile (use cmd-option-o to see script output, remember to click your module before you reload it.) in your Init() area - use this code to see the MIDI devices modul8 recognizes, and what they're named :ĪllMidiDevices = modul8.getMidiDestinationsList() yes, you can do this - but you're going to have to write a module. i've done a little programming on the launchPad - so, I'm guessing they're similar. Too achieve this what would people recommend and also is it possible? - I've finally figured out how to map my controller to modul8 but midi still confuses me I'm really struggling with the next step.īasic wrote:Too achieve this what would people recommend and also is it possible? - I've finally figured out how to map my controller to modul8 but midi still confuses me I'm really struggling with the next step. So when i start performing and start to press the different buttons it will correlate like so in the red - highlighting what has been pressed and staying a solid colour or even blinking to show whats been pressed. (Just to mention the colours dont really matter its just so i can have a visible representation of roughly whats mapped) - the other buttons have no been shown as mapped as this is purely an example. ![]() The green highlights the buttons I have mapped for the clip matrix and the orange highlights the eight different decks i want to map. So i can essentially see what they are mapped too For example in the pictures below the first image shows the desired effect of when the apc is connected and modul8 is running. ![]() when the apc is connected and switched on it maps certain colors to certain buttons I have mapped my apc20 exactly how i want it and even with buttons to spare! ![]() I was hoping to get a little help and to be pointed in the right direction.
0 Comments
Leave a Reply. |